# This is an example configuration file for the DHCPv4 server in Kea.
# It is a basic scenario with one IPv4 subnet configured. The subnet
# contains a single pool of dynamically allocated addresses.

{ "Dhcp4":

{
# Kea is told to listen on ethX interface only.
  "interfaces-config": {
    "interfaces": [ "ethX" ]
  },

# We need to specify lease type. As of May 2014, three backends are supported:
# memfile, mysql and pgsql. We'll just use memfile, because it doesn't require
# any prior set up.
  "lease-database": {
    "type": "memfile"
  },

# Addresses will be assigned with valid lifetimes being 4000. Client
# is told to start renewing after 1000 seconds. If the server does not respond
# after 2000 seconds since the lease was granted, client is supposed
# to start REBIND procedure (emergency renewal that allows switching
# to a different server).
  "valid-lifetime": 4000,

# Renew and rebind timers are commented out. This implies that options
# 58 and 59 will not be sent to the client. In this case it is up to
# the client to pick the timer values according to RFC2131. Uncomment the
# timers to send these options to the client.
#  "renew-timer": 1000,
#  "rebind-timer": 2000,

# The following list defines subnets. We have only one subnet
# here. We tell Kea that it is directly available over local interface.
  "subnet4": [
    {
       "pools": [ { "pool":  "192.0.2.1 - 192.0.2.200" } ],
       "subnet": "192.0.2.0/24",
       "interface": "ethX"
    }
  ]
},

# The following configures logging. It assumes that messages with at least
# informational level (info, warn, error) will will be logged to stdout.
"Logging": {
    "loggers": [
        {
            "name": "kea-dhcp4",
            "output_options": [
                {
                    "output": "stdout"
                }
            ],
            "severity": "INFO"
        }
    ]
}

}