kea/doc/examples/kea4/several-subnets.json

# This is an example configuration file for DHCPv4 server in Kea.
# It's a basic scenario with three IPv4 subnets configured. In each
# subnet, there's a smaller pool of dynamic addresses.

{ "Dhcp4":

{
# Kea is told to listen on ethX interface only.
  "interfaces-config": {
    "interfaces": [ "ethX" ]
  },

# We need to specify the the database used to store leases. As of
# September 2016, four database backends are supported: MySQL,
# PostgreSQL, Cassandra, and the in-memory database, Memfile.
# We'll use memfile  because it doesn't require any prior set up.
  "lease-database": {
    "type": "memfile"
  },

# Addresses will be assigned with a lifetime of 4000 seconds.
# The client is told to start renewing after 1000 seconds. If the server
# does not respond within 2000 seconds of the lease being granted, client
# is supposed to start REBIND procedure (emergency renewal that allows
# switching to a different server).
  "valid-lifetime": 4000,
  "renew-timer": 1000,
  "rebind-timer": 2000,

# RFC6842 says that the server is supposed to echo back client-id option.
# However, some older clients do not support this and are getting confused
# when they get their own client-id. Kea can disable RFC6842 support.
  "echo-client-id": false,

# Some clients don't use stable client identifier, but rather generate them
# during each boot. This may cause a client that reboots frequently to get
# multiple leases, which may not be desirable. As such, sometimes admins
# prefer to tell their DHCPv4 server to ignore client-id value altogether
# and rely exclusively on MAC address. This is a parameter that is defined
# globally, but can be overridden on a subnet level.
  "match-client-id": true,

# The following list defines subnets. Each subnet consists of at
# least subnet and pool entries.
  "subnet4": [
  {
      "pools": [ { "pool":  "192.0.2.1 - 192.0.2.200" } ],
      "subnet": "192.0.2.0/24"
  },
  {
# This particular subnet has match-client-id value changed.
      "pools": [ { "pool": "192.0.3.100 - 192.0.3.200" } ],
      "subnet": "192.0.3.0/24",
      "match-client-id": false
  },
  {
      "pools": [ { "pool": "192.0.4.1 - 192.0.4.254" } ],
      "subnet": "192.0.4.0/24"
  } ]
},

# The following configures logging. It assumes that messages with at least
# informational level (info, warn, error and fatal) should be logged to stdout.
"Logging": {
    "loggers": [
        {
            "name": "kea-dhcp4",
            "output_options": [
                {
                    "output": "stdout"
                }
            ],
            "severity": "INFO"
        }
    ]
}

}